Washi Tape: Where along with How to use of which?
I was one of those of which often forgot the washi tape. Well no more. of which can be used in some many different places along with for so many different things. by home decor to doing cards. Now any room can look great with some Washi Tape. Let's see how.
Washi Tape Box
(Pictured above)
5 Tape Holder
Cardstock – 11 x 6-5/8″
Score on the LONG side at 1, 3, 5-1/2, 8, 10″
Score on the SHORT side at 2, 4-5/8″
3 Tape Holder
Cardstock – 11 x 5-5/8″
Score on the LONG side at 1, 3, 5-1/2, 8, 10″
Score on the SHORT side at 2, 3-5/8″
Stamp all over your box for design your own.
Cut ends shorter that has a little V , then cut each score line; on both sides.
Add adhesive to all for corners stamped side. Fold along with attach little tab to the inside.
Cut the sides of the fold box that has a triangle to the center. Put washi tape around the bottom to hold of which together.
Easy Washi tape switch plates:
Supplies- Light switch plate (pick one up for cheap or just use the one you already have)
- Rubbing alcohol
- Cotton ball
- 2 or more patterns of washi tape
- Craft knife
- Scissors
- Mod Podge Satin
- Foam brush
- Remove your light switch plate by the wall by unscrewing the two screws on the plate above along with below the light switch
- Clean the switch plate that has a cotton ball along with rubbing alcohol to make sure all dirt along with oils are removed along with ensure good washi adherence.
- Starting in a corner, lay a strip of washi tape across the switch plate at an angle. Continue to line up strips of washi tape next to each various other until switch plate is covered. Run fingers over the tape to ensure good contact along with of which all bubbles are removed.
- Flip plate over along with use scissors to trim tape by the edges, leaving a 1/4″ margin past the edge of the plate
- Fold the excess tape over the edge of the switch plate. Use a craft knife to cut an X shape within the rectangular hole. Fold excess tape up along with over the edges of the opening. Use tip of craft knife to poke through the screw holes. Insert along with remove screws to press excess tape toward back of screw holes.
- o protect tape along with make of which easier to wipe off grimy fingerprints, give the switch plate a light coat of Mod Podge Satin applied that has a foam brush within the direction of the tape. Allow to dry completely before re-installing over your light switch.
This specific post is for my friend of which has more washi tape than anyone I know. Ann Sager....... This specific washi tapes for you....... Washi Tape: Where along with How to use of which.
No comments:
Post a Comment